Nucleo-32 board with 3.3 V and External St-Link

Can I operate Nucleo-32 board with 3.3 V input voltage and disconnect on-board ST-link and connect external St-link?

This topic has been closed for replies.

Guru

I'd suggest you review the schematic. Watch for SWDIO, SWCLK, NRST, SWO, MCO/HSE_IN

Tips, Buy me a coffee, or three.. PayPal Venmo (See Profile) Up vote any posts that you find helpful, it shows what's working..

Guru

I'd expect so, the external ST-LINK would need VTarget powered to drive it's buffers

Tips, Buy me a coffee, or three.. PayPal Venmo (See Profile) Up vote any posts that you find helpful, it shows what's working..

Associate III

Thanks for prompt reply.

UM1956 clearly mentions to use 3.3 V SB14 and SB9 should be open. But How do i disconnect on-board St-link?

Guru

I'd suggest you review the schematic. Watch for SWDIO, SWCLK, NRST, SWO, MCO/HSE_IN

Tips, Buy me a coffee, or three.. PayPal Venmo (See Profile) Up vote any posts that you find helpful, it shows what's working..

Sign up