Skip to main content
MRupr.1
MRupr.1
Associate
Dec 8, 2020 11:00 AM UTC
Solved

Hi all, I am looking to start development with the STM32L0 microcontroller. I need a full development kit i.e. IDE, Debugger, Compiler and programming the device. The exact part number of the micro is STM32L031F6P6 (TSSOP 20 pin). Thanks

..

This topic has been closed for replies.
Tesla DeLorean
Tesla DeLoreanBest answer
Guru
Dec 8, 2020 12:00 PM UTC

Keil has​ a free IDE for ST Micro CM0(+) devices.

You'll want an ST-LINK programmer.

And a board with your target part or close proxy.​

Tips, Buy me a coffee, or three.. PayPal Venmo (See Profile) Up vote any posts that you find helpful, it shows what's working..
View in thread

3 replies

Tesla DeLorean
Tesla DeLoreanBest answer
Guru
Dec 8, 2020 12:00 PM UTC

Keil has​ a free IDE for ST Micro CM0(+) devices.

You'll want an ST-LINK programmer.

And a board with your target part or close proxy.​

Tips, Buy me a coffee, or three.. PayPal Venmo (See Profile) Up vote any posts that you find helpful, it shows what's working..
MRupr.1
MRupr.1Author
Associate
Dec 9, 2020 9:26 AM UTC

Thanks for your reply, much appreciated. Would you know which connections I would need to program my board i.e. a datasheet or similar? I am using a TSSOP - 20 pin STM32L0 processor, however can't find any development board with this device. I want to use a device which is either the same or very similar. Would you know of any?

Thanks in advance.

Amel NASRI
Amel NASRI
ST Technical Moderator
Dec 24, 2020 2:55 PM UTC

Hi @MRupr.1​ ,

For hardware connections, you need to refer to AN4467 (Getting started with STM32L0xx hardware development).

-Amel

To give better visibility on the answered topics, please click on "Best Answer" on the reply which solved your issue or answered your question.
Terms & ConditionsAccessibility statement