trying to create a New CubeMX project...... downloading forever

[Javier1]

Is not a new installation of CubeMX v6.6.1, it has been working so far, untill today i try to File>New project.... and stays here forever

trying to unzip "cube-finder-db.zip"

 

[Javier1]

[Javier1]

Similar question from @IMira.1​  a year ago.

I dont get the same error windos

https://community.st.com/s/question/0D53W000010Pe8jSAC/stm32cubemx-stm32f7-error-downloading-the-following-files-crdbfullzip-cannot-unzipped

[Javier1]

trying out @VJADD.1​ answer

a year ago
 
Hello Saram.1
 
 
 
Delete the crdb_full.zip and close the STM IDE. Reopen the IDE and it will work fine. It works fine for me after deleting crdb_full.zip and reopening it.
 
Try it once.
 
 
 
Thank you.

located in

C:\Users\myuser\.stmcufinder\plugins\mcufinder\mcu\cs

 didnt work

[Javier1]

Trying opening CubeMX with admin right , didnt work

[HBoss.1 · Accepted solution]

Hi Javier

I had this problem today too, when I tried to create a new Project in STM32CubeIDE. I could solve it, by deleting the folder C:\Users\xxxx\.stmcufinder\plugins\mcufinder\mcu

I don't know, if this is the same location for CubeMX.

Good luck!

[Javier1]

This did work for me, thanks @HBoss.1​ .

>>I don't know, if this is the same location for CubeMX.

Yes it was

[Javier1]

It happened again today, i think i need to delete the same mcu folder every time i open subemx new project

[Javier1]

apparently it happens randomly , i fix it removing the content off the /mcu folder every time..... not very nice

[HBoss.1]

Probably the cause is antivirus or ransom protection software? Unfortunately I can not check this in my case, since I'm not allowed to switch it off :\