Skip to main content
SAran.1
SAran.1
Associate
March 1, 2021
Question

I am using ST-LINK32/V2 with IAR. I connected it to my Laptop and to the board. Whe I try to debug (click Ctrl_D) I get a messagebox Fatal Error: ST-Link , No MCU device found.

  • March 1, 2021
  • 3 replies
  • 1162 views

..

This topic has been closed for replies.

3 replies

Mike_ST
Mike_ST
ST Technical Moderator
March 1, 2021

This can happen when your target MCU is not powered on.

ST-LInk V2 interface does not supply power.

In order to give better visibility on the answered topics, please click on 'Best answer' on the reply which solved your issue or answered your question. 
SAran.1
SAran.1Author
Associate
March 2, 2021
No, the problem is not the power.
Please note that the first time I connected the ST-Link, it was OK.
Then something happened, and since then I get this message.
Ozone
Ozone
Principal
March 1, 2021

Can other software deal with that ST-Link ?

In former times, there used to be a "ST Download Utility", I think it's replaced by the "Cube Programmer" now.

Toolchains often come with outdated drivers for debug pods, so you might check the version, and try to update the ST Link firmware.

Your debuggee must be supplied by something - either externally, or the ST-Link.

In case of the latter, check if this option is enabled - and if the ST-Link is able to supply your board at all.

Terms & ConditionsAccessibility statement