Skip to main content
CHr
CHr
Visitor II
December 11, 2020
Question

How does one switch the ANT_OFF GPIO pin on the LIV3F?

  • December 11, 2020
  • 3 replies
  • 1018 views

..

    This topic has been closed for replies.

    3 replies

    Sasha1
    Sasha1
    Visitor II
    April 30, 2021

    Did you ever figure this out? I am looking at the same thing. Perhaps it is controlled only by the module when it goes into powerdown and is not able to be changed via a command?

    Tesla DeLorean
    Tesla DeLorean
    Guru
    April 30, 2021

    Similar devices it relates to low power and power down modes, for example when put in a sleep or intermittent wake cycle.

    Signal used to gate LNA or external antenna bias

    Tips, Buy me a coffee, or three.. PayPal Venmo (See Profile) Up vote any posts that you find helpful, it shows what's working..
    Sasha1
    Sasha1
    Visitor II
    April 30, 2021

    Thanks for the super quick response!! So controlled by the module only, correct? Not able to be controlled via software command over UART?

    Terms & ConditionsAccessibility statement