Want know about this error in the picture..?

Forum|Forum|7 years ago
January 8, 2019
2 replies
849 views

Hello,

I am using STM32F070*B Nucleo board want to flash the device using Flash Loder demonstration software using UART communication. but this type of warning message came.

Link that i am following:

http://stm32f4-discovery.net/2014/09/program-stm32f4-with-uart/

This topic has been closed for replies.

Tesla DeLorean

Guru

Indicating the device is not in loader mode. Make sure BOOT0 is high and reset, entry is a one shot deal. Make sure UART being used is supported by loader. Use 9600 with EVEN parity.

Tips, Buy me a coffee, or three.. PayPal Venmo (See Profile) Up vote any posts that you find helpful, it shows what's working..

Ahami.4Author

Associate

hii Clive,

Boot 0 pin is high and device on the loader mode. UART is also supported by the loader,9600,even parity,protection level also checked. i am use the correct pin out. any other reason for this error..?

entry is one shot deal..? you mean delay..?

Sign up

Click below to sign in

Login to the community

Click below to sign in