How to use STM32F767ZI with Arduino IDE?

3 replies
1158 views

Posted on September 18, 2017 at 14:11

I want to use STM32F767ZI , does it provide arduino support for all 114GPIOs or only on few pins. If it does support all the GPIO for arduino then how could I use them?

This topic has been closed for replies.

Tesla DeLorean

Guru

Posted on September 18, 2017 at 15:13

The chip supports whatever software you load on to it.

For Arduino, suggest you go to a place where they are actually implementing and supporting it.

http://www.stm32duino.com/

Tips, Buy me a coffee, or three.. PayPal Venmo (See Profile) Up vote any posts that you find helpful, it shows what's working..

Rishabh GuptaAuthor

Associate

Posted on September 19, 2017 at 12:11

How can I use Arduino IDE for ST32F767? Can you provide me some supporting documents or examples ?

AvaTar

Senior III

Posted on September 19, 2017 at 12:27

I think your question is better asked on an Arduino forum.

The IDE enjoys very little appreciation and support here, and thus your request might not yield results.

Sign up

Click below to sign in

Login to the community

Click below to sign in