Skip to main content
WMaca
WMaca
Associate II
Jan 14, 2019 10:09 AM UTC
Question

Hello, Where to get the Source Code of the EVAL Board STEVAL-ILD004V2 with STM8S103F2 Controller? Can anybody help me? Best Regards, Walter

..

    This topic has been closed for replies.

    2 replies

    AvaTar
    AvaTar
    Senior III
    Jan 14, 2019 10:45 AM UTC

    The link to the firmware provided seems to be a "short circuit": https://www.st.com/content/st_com/en/products/embedded-software/evaluation-tool-software/stsw-ild004fw.html

    Perhaps approach ST directly (FAE or via distributor).

    WMaca
    WMacaAuthor
    Associate II
    Jan 28, 2019 11:18 AM UTC

    I tried to load the demo firmware from ST using ST visual programmer but I got the error below.

    Error : Cannot communicate with the device !

    Check the SWIM cable connection and check all the needed pin connections on the SWIM connector.

    If the application code uses Swim Disable and Reset pin as Output or has disabled SWIM Clock Divider:

    Try Now to SWITCH OFF and ON the application Power Supply while NRST Reset pin is forced low.

    Regards,

    Walter Macamos

    Terms & ConditionsAccessibility statement