Skip to main content
omkardixi
omkardixi
Associate II
March 17, 2022
Question

I'm using STEVAL-MKI182V2 with STEVAL-MKI109V3. So first I tried to check data with the Unico GUI. Then after I integrated the "ism330dlc_read_data_polling.c" example code in my application. But controller is getting stuck while reading the "whoIam r

..

    This topic has been closed for replies.

    2 replies

    AG.8
    AG.8
    Visitor II
    March 17, 2022

    Hi @omkardixi​ , did you try to run the ism330dlc_read_data_polling.c on the STEVAL-MKI109V3? Which project are you using? Note that you have to start from scratch if you want to build a C project on the ProfiMEMS, since it is not open source form ST.

    AG8

    omkardixi
    omkardixiAuthor
    Associate II
    March 18, 2022

    Hi @AG.8​ Yes I have integrated the same example code In my project and using the STEVAL-MKI109V3 board. Regarding the project, I made my own new project where I have enabled the SPI2, TIMER3 and the UART(using STM ide tool).

    Can you suggest to me any document or code which can help me to understand the initialization of the spi more?

    Terms & ConditionsAccessibility statement