About Jad

Jad · 2024-12-12

Good morning, I want to calculate the power consumption of my teseo vic3DA EVB, unfortunately, the datasheet do not talk about it, I just see in the schematics, it can be powered by 12V, 5V or 3.3V but nothing about the input resistance or the total ...

Jad · 2024-12-07

I am working on the Nucleo C031C6 and struggling to use the virtual com port. The datasheet says that the virtual com port is connected to PA3 and PA2, so I want to send data to my computer with USART2. Unfortunately, I do not understand why the pins...

Jad · 2024-12-05

Good morning, there is something i a not understanding well with my board. I need to use 10 GPIO as inputs of button or output. for that i went to the GPIO list, for example, I got GPIO at pin PI4 so I go on the schematics of my board and I see that ...

Jad · 2024-11-28

good morning,I am actually working on my STM32G431KB, I will use the power consumption tool of STM32cube once my code is complete but I would like to know if for now my calculations are correct.I want to use my board to power up 11 different sensor ...

Jad · 2024-11-14

Good morning.I am wiling to use the STM32G4 Nucleo-32 board (MB1430) board for an analog to CAN use. I would like to know if I could power up my 10 5V sensors. so i would like to know if I can use the +5V of my board and the current capacity of it to...

Jad · 2024-12-05

Thank you for the response, it responds exactly my question , I wanted to use this pin because I wanted to use 10 GPIO so I wanted to use all of them presented on cube mx

Jad · 2024-12-05

I am using stm32h7b3, so I guess there is no way to access this ball even with soldering right?

Jad · 2024-12-05

I did not understand what ball means, but my issue is finding the pins in my physical board: there is no arduino hole to put a jump wire in a hole named B2

Jad · 2024-11-28

Yes exactly

Jad · 2024-11-14

ok, I do understand the issue of having two nucleos in series. I wanted to do this to use the least current possible from my battery, but now I guess the best thing to do is to connect all my Nucleos in parallel. For the calculation of the MCU power ...

User statistics

User Activity

VIC3DA Power consumption

Nucleo C031C6 Virtual COM Port problem

GPIO output in real life - STM32H7B3I-DK

Power consumption of my HW

supply power from Nucleo STM32G4

Re: GPIO output in real life

Re: GPIO output in real life

Re: GPIO output in real life

Re: Power consumption of my HW

Re: supply power from Nucleo STM32G4