About sjones

sjones · 2024-04-30

Following on from Solved: Cannot connect STWBC86 to WPSTUDIO V1.8.4 - STMicroelectronics CommunityI am still getting the "Unable to find an [TX]WBC86 device"' message when' I try to connect.Originally the log file just showed the 'Failure to load DLL...

sjones · 2024-05-03

Hi, I did some more testing. I isolated the STM TX chip from the FT260 chip by removing the jumpers on P2. I connected a bus pirate board to the I2C SDA/SCLK/GND (and set the 5V pull up on the bus pirate) I then used the bus pirate to generate ...

sjones · 2024-04-30

Just a couple more things...I have jumpers on the SDA, SCL and INT headers of P2The board has LEDs D6 (power) and D5 (I2C initialised) illuminated.On power up, or pressing the S1 reset switch I get the following on the I2C bus:

sjones · 2024-04-23

I tried installing both x86 and x64 versions of “Microsoft Visual C++ 2015 Redistributable” in turn, rebooting after installation, but still unable to detect the board. Same errors as before.

sjones · 2024-04-22

There seems to be some confusion here:The STEVAL-WBC86TX board has an FT260 chip on board. This does the I2C to USB interface, and so (I think) replaces the need for the FT260 dongle mentioned above. The user guide for the board (UM3161) certainly do...

sjones · 2024-04-22

The FTDI Application note athttps://www.ftdichip.com/Support/Documents/AppNotes/AN_394_User_Guide_for_FT260.pdfSays that (1.1) a custom driver is not needed as HID is natively supported by most operating system, and that there are 2 interfaces (I2C a...

User statistics

User Activity

Problems connecting to STEVAL-WPC86TX with STSW-WPSTUDIO

Re: Problems connecting to STEVAL-WPC86TX with STSW-WPSTUDIO

Re: Problems connecting to STEVAL-WPC86TX with STSW-WPSTUDIO

Re: WLC dongle driver issues Unable to load DLL 'HidDongle.dll'

Re: STSW-WPSTUDIO GUI cannot connect to ST Wireless Charging board

Re: STSW-WPSTUDIO GUI cannot connect to ST Wireless Charging board