About GauravK

GauravK · 2025-01-07

Hello,I was able to update F429 using boot-0 and CubeProg tool via USB. But requirement was to update without boot-0 pin. Please suggest alternatives for update from USB.Also wanted to know: I tried changing boot-0 to do DFU, using SW and HW reset bu...

GauravK · 2024-11-07

Hello, Can I know any available settings to reduce I/O speed. The idea is to reduce power consumption by F429. CubeMX doesn't allow to change I/O speed.

GauravK · 2024-11-05

Hello, USB HS is used as MSC with external PHY is running ok. Want is to reduce power, by trying low-power code gets stuck and I need help on enabling same?

GauravK · 2024-09-25

Hello,Im unable to connect to internet in IDE and MX. Check below image in IDEBelow seen in MXMy work is getting hampered due to this. Please let me know what to do.

GauravK · 2024-09-24

Hi, a project runs in below trace in debug. I use external V2 ISOL debugger.But program seems to run when I download. Pl let me know if more inputs needed.

GauravK · 2025-01-07

Hello @TDK , Thanks for providing information.I tried this by changing device to F4. But there is hard fault on jump. Then looking at the web further changes I found was:SYSCFG->MEMRMP = 1; I was able to get in DFU.Also I saw changes people have:usi...

GauravK · 2025-01-07

Thank you @TDK I wanted to know:any steps to follow for getting into bootloader for update from USB while application is running?Is USB FS configured as DFU sufficient or any other setting required?

GauravK · 2024-11-13

Hello @Peter BENSCH ,no confusions,I want to know how to change IO speed, for that there is no solution providedThere were comments that clock won't affect power consumption, so I found tool showing CPI clock changing powerSo Im ok with any other sol...

GauravK · 2024-11-12

Hello, thanks for all replies. wanted to know then why cubeMX has below options, which lower consumption by reducing cpu freq

GauravK · 2024-11-12

Hello @FBL , Thanks for replying, the changing unused IOs to analog option got me into a issue, where by Im not able to re-program the controller F429 custom board, the debugger refuses to identify the controller, causing unable to change the program...

User statistics

User Activity

Program update over USB

reduce I/O speed to save power

Reducing power while using USB

Internet connection

exit in touch debug

Re: Program update over USB

Re: Program update over USB

Re: reduce I/O speed to save power

Re: reduce I/O speed to save power

Re: Reducing power while using USB