STM32CubeProgrammer v2.18.0 release information New features: Added the support for the STM32N6 series– OTP programming– External memory programming– Serial boot via USB/UART– FSBL signature with stm32header V2.3 through the signing tool• Added the ...
Hi I have been using Atollic for years , with the cheap stlink programmers from AliExpress. I havent had any issues, but just recently updated to STM32IDECube (V1.13.0) , and STM32CubeProgrammer (V2.14.0) . I purchased an original ST32Link-V2 , but ...
I am working with a NUCLEO-WB15CC, and it seems that I can't read or write anymore. When I connect via ST-Link in STM32CubeProgrammer (v2.14.0) I just get Error: Data read failed When I try to read registers, I get the same error.I also can't erase t...
STM32F446, locked to RDP1, BOR set to 3 is incorrectly read out/displayed [EDIT] see next post [/EDIT] in CubeProgrammer v2.12.0:The same chip read out by STLink Utilities:Note, that the write protection is read out/displayed correctly (although very...
Hello all,I'd like to know if there is a set of acceptable UART baud rates for CLI use (CubeProgrammer CLI defaults to 115200 baud for UART).Looking at the GUI for CubeProgrammer, after selecting UART, it shows that a baud of 460800 or 921600 is poss...
When loading a .hex file into flash, the STM32CubeProgrammer (v 2.13.0) miscalculates which sectors to erase and as a result, the download often fails unless the region being loaded has been previously erased or happens to contain the same values.For...
I see a FAIL.txt file in the mass storage that says "The interface firmware FAILED to reset/halt the target MCU".LD1 and LD3 are red.I cannot even load the simple programs like Blink LED using any IDE.The on-board F401RE chip is quite hot. Dropping a...
I'm using a STM32U5A9J-DK with TouchGFX. Smaller projects work just fine. But aufter integrating an Animated Image (approx. 37 MBytes of assets), the programming fails. The console log is as follows:STMicroelectronics ST-LINK GDB server. Version 7.3....
Haven't found anyone talking about the new API here. I'm trying to code a program that flashes a STM32F334, reads processor's UID and post it to a proprietary database. STM32CubeIDE and CubeProgrammer works fine. I also managed to run C++ API and ide...
