Ask questions on STM32CubeProgrammer and find answers on device detection, connection failure, programming issues, and more.
We are pleased to announce that STM32CubeProgrammer 2.21 is available What is new in 2.21: • Support for the STM32WL3Rxx microcontrollers: – Internal memory programming – Option byte and OTP programming – PKCS#11 – Firmw...
Hi everyone,I'm working with an STM32F103C8T6. Even though I haven't programmed any code onto it myself, when I connect with STM32CubeProgrammer, the Registers panel immediately shows “SLEEP” (while on other ST boards it would show “HALTED”). Because...
Hi,I am trying to read peripheral registers on the H523 using STM32_Programmer_CLI.CLI parameters : -c port=SWD -r32 0x42020800 52Result:0x42020800 : FFFFFFFF FFFFFFFF FFFFFFFF FFFFFFFF0x42020810 : FFFFFFFF FFFFFFFF FFFFFFFF FFFFFFFF0x42020820 : FFFF...
I designed a pub board for stm32h743vit6, I connected mcu to stm32programmer via usart1,and sad port also reserved.But when I clicked "connect",it showed mistake:00:37:16:773 : RTS low00:37:16:774 : DTR Low00:37:16:833 : Serial Port cu.usbmodem000063...
I'm trying the program an STM32G0B1RET with the STM32CubeProgrammer. It seems the programmer sends a 0x7f and the MCU responds, but maybe too late to connect?
I have a customized pcb with stm32l476 as the mcu and stm32f103 as a debugger. Since my debugger is not flashed i am using an external st-link from the nucleo-l476. When i try to connect it in the normal mode and reset mode, STM32 Cube Programmer gi...
Hi,Yesterday I found on YouTube a video from ST that showed how to read firmware from(!) an STM32 board to a pc using STM32CubeProgrammer. Today, I cannot find that video. Could someone from ST please point me in the direction of that video ? Thanks....
Hi everyone, History:I am running from bank 0 and I start an upgrade after the upgrade I do a bank swap and the application starts running from bank 1.Problems:Now I use a debugger to flash the .elf file in the micro-controller. But the code does not...
Working with CubeProgrammer connected to a Nucleo-G0B1RE board, a binary file needs to be stored starting from address 0x0800_C000 on the chip. However, when the `Start Programming` is initiated, the process fails immediately as can be seen in the a...
After update to the latest Cubu Programmer v2.20 a get this error when uploading the firmware:11:29:37 : Opening and parsing file: 1000BASET1-MC-ETH v1.3.hex11:29:37 : Memory Programming ...11:29:37 : File : 1000BASET1-MC-ETH v1.3.hex11:29:37 : Size ...
Hi allFor the STM32U5, the reference manual shows the GCCFG register as but STM32CUBEIDE showsbit 16(and a lot of other bits) are differing. Is this an error and if so which is the right one
