We are pleased to announce to you that the release 6.13.0 of STM32CubeMX is available. What is new in 6.13.0: Added support for the following series, microcontrollers and microprocessors: STM32N6, STM32U3, STM32WL3x, STM32G411xx and STM32C0Added the ...
Hi, I know this question have been asked several time, but STM32CubeIDE and STM32CubeMx are only generating .c file... this is very frustriating, time consuming and source of multiples error when working with cpp environment. We have to manually rena...
This is a question about automatically generated code.When we change the ioc file in STM32CubeIDE, there is some code that We don't want to be overwritten by the automatic generation. How can we avoid this?Specifically, We have changed the value of H...
CubeMX does not provide the option to choose whether GPIO pins should be initialized from the CM0+ or CM4 core. As a result, the generated code lacks GPIO clock definitions, GPIO ports, and pins. This prevents further progress and requires manual des...
As long as my .ioc file has the linesVP_EXTMEM_MANAGER_SIG_Activate_EXTMEM.Mode=Activate_EXTMEM VP_EXTMEM_MANAGER_SIG_Activate_EXTMEM.Signal=EXTMEM_MANAGER_SIG_Activate_EXTMEM in it, CubeIDE and CubeMX will be unable to open it with the error:Cannot ...
Hello, my problem, that uIP-Stack has TCP-Retransmissions with HTTP-trafic. That was observed with Wireshark. The same uIP-Stack works at STM32F7 properly. I'm not sure about Settings in CubeMX with Descriptor Address and Size. My settings are like f...
I can't seem to get CubeMX to install the CMSIS package. I have tried downloading directly from CubeMX, downloading .pack file and installing it from local (from Keil, arm, and even ST's github).I get an error "Problem during load of selected file.....
So after having a firmware update, this popped up on my screen. What do I do next. NB, I've probably chosen a wrong label because I don't even know what to label this with
I am use STM32L431RCT6，and my CubeMX config is this:And my code is:```uint32_t data = 128;ret = HAL_DAC_SetValue(&hdac1, DAC_CHANNEL_1, DAC_ALIGN_8B_R, data);if(ret) {HAL_Delay(10);}ret = HAL_DAC_Start(&hdac1, DAC_CHANNEL_1);if(ret) {HAL_Delay(10);}`...
Ubuntu 23.10Tried to load an older project in 6.12.0, CubeMx Asked to convert or continue. Selecting continue.IT start to unzip the tarball and then stops. cube has no error screen, but the log shows as followsUpdating to CubeMX 6.12.1 yields the s...
Background:Using an specific MCU, and after a board build, found that needed more memory. But a part in the "F" family with same pin out did not exists. To find another part, used the selector to select certain features to get close to a number of p...
