We are pleased to announce to you that the release 6.13.0 of STM32CubeMX is available. What is new in 6.13.0: Added support for the following series, microcontrollers and microprocessors: STM32N6, STM32U3, STM32WL3x, STM32G411xx and STM32C0Added the ...
In STM32CubeMX, when I enable an I2C interface in SMBus mode (and no other I2C interfaces are enabled), the resulting code emitted in file stm32f4xx_hal_conf.h has this line commented out:/* #define HAL_I2C_MODULE_ENABLED */As a consequence, stm32f4...
This does not happen with STM32CubeIDE 1.4, but I need to use 1.5 for various reasons. The computer doesn't have and can't have an internet connection.I've downloaded the file en.stm32cubef4_v1-25-0.zip, AND en.patch_cubef4.zip (this is V1.25.2 accor...
Hi,we have configured OCTOSPI1/2 follows : But signal ChipSelect is not changing when we measure it. When we moved Chipselect to OCTOSPI2 ChipSelect is working ... How do we have to change configuration to work with ChipSelect on OCTOSPI1 ?ThanksPetr
I just realized STM32CubeMX Version 6.0.1 no longer sorts and groups the settings in .ioc file in a predictable way. This makes it very difficult to follow the changes with tools like `git diff`. #MicroXplorer Configuration settings - do not modify P...
Hi, we use Git for source control and have notice that each time STM32CubeMX 6.1.1 saves the IOC file, the ordering of all the entries is changed. This makes it impossible to deal with in pull requests as you cannot tell if genuine changes have been ...
Hello ST community,I am use NUCLEO-G474RE, wanted to set up SYNCOUT for HRTIM. You can see the synchro configuration below:Timer A is running, PWM is generated, but nothing happens to SYNCOUT. I start looking at hrtim initialization and notice that t...
I try to capture power off timestamp by using PVD_IRQHandler(), but it doesn't work. The PVD is configured at power up at below:void Config_PWR_PDV(void){ PWR_PVDTypeDef PVDSetting; HAL_PWR_DisablePVD(); PVDSetting.Mode = PWR_PVD_MODE_IT_FALLING; //F...
Hello,I am using the STM32L412, when I activate the HSI clock in the .ioc, HSI Calibration Value is set to 16 (0x10).Looking at stm32l4xx_hal_rcc.h:#if defined(RCC_ICSCR_HSITRIM_6) #define RCC_HSICALIBRATION_DEFAULT 0x40U /*!< Default HSI ca...
I hope this is a good place for this. I had difficulty getting an SD card read to work with FATFs code generated by CUBE. The file at first appeared to get corrupted after about 20K bytes and I spent considerable time trying to figure out what I was ...
I am trying to STM32G4 with STM32-MAT.After setting the setting I want to use to STM32CubeMX, when I set HRTimer Config on Simulink and created the code, it stopped with the error "Undefined identifier hrtim_adc_trigger3_value_init".I don't know whic...
