I've asked Segger but I was wondering if anyone knows how to get a Segger J-Link/Trace to put only the M4 core on an STM32MP157 into reset and bring it back out?
so how can I add into the linux distribution so that firmware will build and load along with linux and load in bootupFYI : Iam using Yocto for building
Hi everyone,I have tried to check eval board PCB with hyperlynx DDR wizard but I can't.I downloaded all of the IBIS data which are Nanya DDR3L ram and MP157A.However, I'm confused about which ODT models I should choose.Please help me which model I ch...
hi,i would like to modify the start_up_demo_launcher.sh script as well as the weston.ini file so that my application is started instead of the STM demo application. i would then like to add these files to my own distribution package so that i can fl...
I am trying to verify my build environment by building the U-boot code samples to be able to run the DDR Tuning tests.First I start CubeMX (using the ubuntu image provided on one of your workshops) and under tools i choose the DDR Test Suite and sele...
Hi,I would like to know for the board how to enter low power mode. I am using a version, openstlinux-5.10-dunfell-mp1-21-03-31. Please let me know how to address it.Best Regards,Sun
Hi,I would like to compile a user space c++ application on the STM32MP157C-DK2. Is it possible to install GCC or G++ on the board?I tried installing them via apt-get but seems like there is not any package with name gcc or g++.How can i install it an...
Hello,We are using the LBEE5KL1DX-883 WLAN+BT chip with a STM32MP157C on a custom board. The SDIO interface is routed to the SDMMC3 interface (different from the DK-2 board). However when we are probing the brcmfmac module, it cannot find the mmc0 in...
My STM32MP157F-DK2 is powered by 5V 3A PSU. but at the boot up time, always it displays the warning ***************************************************** WARNING 500mA power supply detected ** Current too low, use a 3A power supply! *******...