Hello,we have an issue with a STM32MP1 and EMMC. The only boot source is SDMMC2 from eMMC-Flash.So far it works fine, but when we try to initiate a "reboot" in linux the system hangs and won't start again. If we do a reset in u-boot, there is no prob...
Hello, I was wanting to make my own camera board and I wanted to use the same camera that is on STM's Camera board MB1854 and I looked up that manufacturer part number (AS-BC538A3M6-63(1.02.A3265)) and nothing showed up, and when I looked up just AS...
I am trying to debug a simple application on the CM4 processor on a STM32MP157D-DK1 development board in engineering mode using Cube IDE Version: 1.18.1 The board is booted from the micro SD card and appears to be powered up and alive with various fl...
I have a new STM32MP157D-DK1. I have booted the board using the enclosed SD card and all appears to be working. The green LED next to CN6 is on, blue LED8 starts flashing a few seconds after power on. One of the block of 4 red LEDs next to the ST-...
hello, i have an issue trying to install QT expansion package on stm32MP257F-DK2 with openstlinux starter package provided with the board.i am using instructions from:https://wiki.st.com/stm32mpu/wiki/X-LINUX-QT_Expansion_Package#Software_setupwget ...
Moved from MCUs forum.I met this error and can not continue flashing the board. Could any one help me? All configurations are same with https://wiki.stmicroelectronics.cn/stm32mpu/wiki/STM32MP25_Evaluation_boards_-_Starter_Package#Downloading_the_ima...
Hi , i am using the stm32mp157DAC processor , where in custom board i added the emmc with SDMMC2, in my hardware there is 3 bootpin, boot0 boot1 boot2 .i did changes in u-boot DTSi did changes in Linux DTS only in u-boot DTS i added this line in SDM...
Hello ST Team,We are planning to use the STM32MP2 series MPU in one of our design. We have found the below link for the validated DRAM with the STM32MP2 processor. We want to know other than that is there any other DRAM is validated with the STM32MP2...
Hello, We recently bought an STM32MP257f-dk board. We are running OpenSTLinux on it. We would like to connect a modem to communicate with the board via 4G. We're thinking of using a USB modem.Do you have a list of recommended modems or modems nativel...
Hi,I've lost the power brick for my STM32MP15X-EVAL board. It's a 5v-3a barrel connector, but I don't know the polarity and it's not written on the board or anywhere.Does anyone know where I can find a replacement, or the exact spec of the power bric...