Dear all, The X-CUBE-MATTER Expansion Package is now available on our official website following this link MATTER - Matter software expansion for STM32Cube - STMicroelectronics It is a reference implementation for the demonstration of Matter on ST...
Please go and visit our wiki pages where you can find a lot of information on our wireless product families (WB, WBA, WL) and the supported protocols: BLE, Zigbee, Thread, Matter, Lora, ... To begin your technical journey, please start from this top ...
Hello Community,Greetings of the day.I'm using the Nucleo WB55RG board. I'm trying to initialize and connect the wb55rg BLE with my mobile app.So, I'm following the stm32wb getting started video series, video part-12b. (video link - https://youtu.be/...
Colleagues.The STM32Cube_FW_WB_V1.20.0 library for STM32Cube_MX version 6.12 allows me to create DMA2 channels for B-WB1M-WPAN1. However, the startup_stm32wb1mxx_cm4.s and stm32wb1mxx.h files do not contain DMA2 interrupt vectors. Error[Pe020]: ident...
We are developing a Matter device using X-CUBE-MATTER.When we set CFG_FULL_LOW_POWER to 1 to enable sleep mode, pressing B1 for 10 seconds does not enter Factory Reset and BLE advertising is not executed.When we checked the current consumption, it se...
I want to write a function for the STM32WB55 where BLE advertising is always active, and the processor performs the necessary tasks, then sleeps and wakes up using RTC Wakeup.I want to do it with STOP2 mode, but my processor consumes 3mA and does not...
Hi,I have the problem, that my MCU seems to loose its connection to the network quite often (after some minutes or hours usually) and is therefore not usuable.I would like to detect this in my Application and then trigger either a rejoin (if possible...
Hello,here in my code I want to send the received values of the payload directly to USART2. This works fine if I send less than 20 characters. If I send more, the program chrashed.case P2P_SERVER_UART_C_WRITE_NO_RESP_EVT: /* USER CODE BEGIN Ser...
Hello,I am looking to add an STDC14 header to my design.I am concerned that by putting such a connector on the board, this will allow 3rd parties to simply buy an STLINK and reprogram my device.I am not familiar with STM32, so in the interest of spee...
Hi,I have copied a sample project from STM32Cube_FW_WBA_V1.4.1 to another location.After importing the project into CubeIDE1.16.1 and compiling it, I got the error message:make: *** No rule to make target 'C:/Utilities/trace/adv_trace/stm32_adv_trace...
Hi, i have started testing the STM32WL Nucleo-64 with the Lorawan End Node Firmware. At first it seem to run OK, the device connects to the gateway and the data packets reach the platform i use. But the device stops working correctly with a few mwter...
Hi,I'm working with the STM32WLE5JC mcu and Cube firmware 1.13.0. Can someone explain how the module/stack implements adaptive data rate? I can see from lora_app.h that it is enabled by default, but exactly how is it implemented?The screenshot is fro...
