SysTick_Handler() function isn't called in a project based upon the STM32G070CB mcu (48 terminals). However, with the STM32G070RB (64 terminals (NUCLEO-G070RB)) there aren't any issues. I found this workaround from 3 years ago (almost 4):https://comm...
Both STM32H75X and STM32H7B0xB have SAR ADC, what are the differences between them?How to make the selection when using SAR ADC?Thanks,
Hello everyone, I'm interfacing an INA228 with an STM32 microcontroller via the I2C bus. However, I'm facing a problem with the communication that I can't seem to resolve.Setup Details:Microcontroller: STM32h7 (using HAL library)INA228 connected v...
Hello,Can you please check if STM manufactures controllers with Sinusoidal PWM, our requirement is to drive 2 H-bridge full drivers, so if they are available please let me know. Thanks,Sonali
**Problem:**- When the I2C is enabled, the part can hit the WWDG.- It looks like the pointer to the function `XferISR` is getting set to NULL somehow. - When this happens, the interrupts are not cleared, and it continually fires the interrupt becaus...
Hello I'm working with a nucleo u575zi-q board where i've to set many GPIO pins in a synchronos way using GPDMA. I've successfully used the DAC and DMA example in the IDE, but Igot stacked with the GPIO output. I followed the case posted here, triyed...
Hi, Is there any free IDE for NUCLEO-H753ZI board?Thanks,Peter
If I run debug, I always got hardfault. Here is source codes that cause hardfault. flight_data.imu0_accel = imu0.getRawAccel(); flight_data.imu0_gyro = imu0.getRawGyro(); flight_data.imu1_accel = imu1.getRawAccel(); flight_data.imu1_gy...
When I give the delay time greater than 300 for the code below (500ms or 1000ms), GetTick or HAL_Delay(500); functions do not work.If I make the time 100ms, 200ms or 300ms, it works.When I want to control the delay at longer times, the program does n...
Hello Everyone I am using FATFS on STM32F401RE, with the code generated by CubeMX, which is version 6.12.0. When I perform the mount operation, the return value is FR_NOT_READY. However, initializing the SD card through the HAL library and reading SD...
