Sorry, can I use STM32F407VET and STM32F4 Discovery board in CUBE IDE version 1.17.0. If so, tell me where I can find information on how to implement it. I tried on STM32F404VET and when compiling, it says that it does not see the controller.Thank
Hi,I am working on the electronics design and configuring the micro through CubeMX to decide which pins to connect to which pins.We need to read a quadrature encoder (ideally also with the index) and at the moment we have wired the micro/PCB as per a...
Hi,I'm looking for baseband processor for my IQ receiver. I would need dual 12-bit ADC with 5.12MSPS rate. I hope to get data from two ADC to DMA syncronously.I have been looking for STM32H745 for this task. Based on the datasheet, maximum sample rat...
Make dual data line SPI running on nucleo-H743zi2, using SPI-2 as master and SPI-3 slave.
I am trying to add 5 to the received number but I can't figure out what am I doing wrong.This is the code from Keil uint8_t receivedNumber; uint8_t newNumber; while(1){ if(HAL_UART_Receive_IT(&huart2,(uint8_t *)&receivedNumber,sizeof(receivedNumber)...
Hi and thanks in advance !My application uses a STM32G0B0 to control an LED driver through PWM among other things (pin (26)-PB14).The device can receive commands and I have added an option to jump to bootloader through a special command to perform fi...
Please give an example of IAR external SPI_FLASH(W25Q128) download algorithm for STM32F429IG, thank you
I tried everything to send a simple wave through the DAC pin using HAL and STM32CubeIDE to configure the project. What I've checked that works: - Clock source- Trigger source- Output pin configuration- Built-in triangle and noise wave generation. I t...
Hi ! i have found that if you try to select power voltage detector in (external input analog voltage) on Cube Ide there is a missing line in the code generated that make the code don't workhere an example of code generated for the option with the int...
