HelloRecently I started working with STM32F072B-discovery board and noticed that the DFU example given by STM32Cube_F0_FW_1.9.0 breaks. When you reset the board the output of dfu-util looks like:sudo dfu-util -l dfu-util 0.8 Copyright 2005-2009 Wes...
Hi everybody !I've tried to implement the additional features given in X-CUBE-DSPDEMO (to use, for exemple FFT) to a project for my STM32H743I_EVAL board. The "H7" has like "F7" the ARM M7 in it so it says that DSP operation could be implemented on F...
Hello everyone. I would like to know if there is any ST sales office in Shanghai? Where is it located? Can I go or contact with them to buy an STM32 Nucleo board?.Thanks in advance, Yosmany.
Can we take TIMER2, Channel3 for External clock mode1 for frequency counting upto 5-10 MHZ? Board: STM32F401RE [Nucleo Board], PIN: PB_10 [Timer 2, channel3].In case, yes.. Can anybody provide me refrence or sample code?
Most signal i have found on MCU but I haven't find any pins RAS#, CAS#. CLK. CKE on STM32L476ZET6. Can i use GPIO to interface the this signal?
Hello, I am trying to use the STM32l011k4 with the Sharp memory display breakout from Adafruit. I succeeded in clearing the screen but I can't display a pixel on the screen. I always have the same display, probably what the buffer contains. I don't k...
I'd like to amplify two signals connected to non-inverting input of OPAMP and control which one is currently amplified by TIM1, Channel 6. This technique is described in RM0316 document, chapter 18.3.6 Timer controlled Multiplexer mode.I've set TIM1,...
I have managed to get STemWin showing the "Hello World" message on the STM32F779I-EVAL board using CubeMX.The project has FreeRTOS enabled.Maybe it's me not understanding STemWin... but it seems after the screen refresh during the initialization, STe...
