How to use STMicroelectronics classic USB device middleware with STM32H563ZIT6

Forum|Forum|2 years ago
September 5, 2024
4 replies
1165 views

HI,

I am trying to interface the USB device with a customized STM32H563ZIT6 controller board. I followed the example steps from the STM Community, but the USB port is not detected. What should I do?

https://community.st.com/t5/stm32-mcus/how-to-use-stmicroelectronics-classic-usb-device-middleware-with/ta-p/599274

https://community.st.com/t5/stm32-mcus/how-to-implement-a-usb-device-composite-in-stm32h5/ta-p/708078

Anyway, I will upload my project. Please verify it

HSP200_V_0_01_05SEP24_CW_01_-USB_PRE_DEFIND.7z

STM32H5 series

This topic has been closed for replies.

Best answer by FBL

Hi @Berlin-raj123

I would add that if you need any recommendations about Hardware design you can refer to the board provided schematics. https://www.st.com/resource/en/schematic_pack/mb1404-h563zi-c01-schematic.pdf

Pavel A.

First of all, get (buy, rent, steal) a real hardware USB analyzer, to see what is actually transmitted on the wires.

When the electric layer is good you can use software USB analyzers.

B

Berlin-raj123Author

Associate III

@Pavel A.Are there any other methods? When I verified the USB interface with the STM32F429ZIT6 controller, I did not use any analyzer.

Pavel A.

If the electrical interface has been validated, next step: capture USB traffic, act based on observations. Does enumeration begin at all?

F

FBLBest answer

ST Technical Moderator

Hi @Berlin-raj123

I would add that if you need any recommendations about Hardware design you can refer to the board provided schematics. https://www.st.com/resource/en/schematic_pack/mb1404-h563zi-c01-schematic.pdf

To give better visibility on the answered topics, please click on "Best answer" on the reply which solved your issue or answered your question.Best regards,FBL

Sign up

Click below to sign in

Login to the community

Click below to sign in