Hello ST community,I have a question regarding the HID functionality of an STM32 controller.I have realised a (driverless!) joystick with an STM32 controller. So far everything works fine.However, I would like to write additional PC software that can...
(1) TIM1_SMCR and TIM2/3_SMCR have different naming convetions for SMS / TS fieldsi.e. for TIM1_SMCR there are SMS/SMS_1 and TS/TS_1 and for TIM2/3_SMCR, SMS1/SMS2 and TS1/TS2 respectively.(2) Also TIM1_SMCR_TS_1 field has no enumerated values, while...
HelloWe are using the Nucleo-f439zi (STM32F439ZITbu microcontroller) https://www.st.com/resource/en/reference_manual/dm00031020-stm32f405-415-stm32f407-417-stm32f427-437-and-stm32f429-439-advanced-arm-based-32-bit-mcus-stmicroelectronics.pdfWe have s...
I am trying to prototype ethernet on the NUCLEO-H7S3L8 eval board. When enabling ethernet through CubeMx using the same configuration I've used on the NUCLEO-H563ZI, the ethernet driver fails initialization. Is there an alternative Ethernet driver th...
Good morning everyone,I'm here to ask for advice regarding the approach I want to take for enabling firmware updates by non-expert users.I have built hardware that uses the STM32F103, and over time I will certainly release updates. Currently, I'm usi...
Hi,The requirement is to port MQTT of NetX Duo to STM32f412 ,without the need to use the TCP/IP and TLS addons in NetX Duo. Since we have DIGI XBee's modem and we will use its TLS socket for communications. I have the secure-socket-like interface r...
HELLO,I am working with the LwIP MQTT client(stm32f407) and trying to connect securely to Azure IoT Hub using port 8883. I have enabled secure TLS connections by defining LWIP_ALTCP and LWIP_ALTCP_TLS. However, I am facing a connection reset issuemqt...
Hello everyone,I have a project using the STM32H7, using FreeRTOS and with a FatFS (ChaN) runnin on a 4GB eMMC (Kingston), using peripheral SDMMC1.Normally everything works fine. SDMMC1 and FatFS (FAT32) are initialized at main, before OS, and is use...
I made a project on keil with generate flm file to download to external flash with my board. My board has a stm32h7b0zbt6 chip with ospi interface with a spi nor flash W25Q128. the interface releate is: PF6 ------> OCTOSPIM_P1_IO3 PF7 ------> OCTOS...
I am working on a project using the STM32U5G9ZJT6Q MCU, where I am trying to receive data from an 8-bit DCMI interface using GPDMA in circular mode or normal mode. The data is being captured from an 8-bit parallel bus, and I am using GPDMA to transfe...
