Posted on December 13, 2016 at 07:54Hi,I want to ask question about USB On-The-Go host and device library, How can I differentiate host and device part in this library(UM1021) and how this library is different from USB-FS-Device development kit(UM04...
Posted on December 13, 2016 at 09:18Hi all,I would like to implement USB communication at 50Mbps using STM32 as a device- based on ST's existing example code.I would like to understand if this is possible to achieve using the standard example code a...
Posted on December 11, 2016 at 03:15Hi.I am developing for an STM32F4. I'm using STM32CubeMX and System Workbench for STM32. I'm using FreeRTOS. I would like to know how I should, and should not, be using the STM32F4 HAL Driver callbacks. As an exam...
Posted on December 09, 2016 at 09:39I have designed two different data acquisition boards with STM32F407 MCU. Everything is OK. Now I would like to customize the USB CDC driver. I changed the MFG name in the .inf file provided by ST. This works in W...
Posted on February 14, 2016 at 16:01Hi,I tested the official USBD MSC exemple with a stm32f746-disco board in HS mode, and I got a very bad speed. For several high speed sd card, I got write:400KB/s, read: 1.6MB/s.Then I tried to increase the MSC_ME...
Posted on December 09, 2016 at 21:31Hi,I'm trying to read SD card using Mass Storage Protocol via STM32F746-DISCO board. I found example in Applications\USB_Device\MSC_Standalone which does exaclty what I need. However the read/write speed is bad. I...
Posted on December 08, 2016 at 22:38Hi all, I'm working with Ethernet on an STM32F745IETx and with a project configured using STM32CubeMX. We're using an RMII interface to a chip that supports three Ethernet ports. I've tested pass through between t...
Posted on December 08, 2016 at 19:27Hi everyone,I'm trying to use the STM32F429-Disc0 board with CubeMX as a CAN to USB bridge but I'm running across very strange behaviour now.I've made it to the point where the device gets enumerated correctly by ...
Posted on November 27, 2016 at 03:51 Anyone figure out how to run the examples downloaded with Cube ? I am using the f0, r8 chip with the nucleo board. I have been programming using bare metal (registers) and some spl to learn about the chip. No pr...
Posted on December 08, 2016 at 09:38 I'm trying to send data by STM32f103 to an Arduino board using UART. Data isn't received properly. The code is generated using STM32CUBEMX and here is the part I added: uint8_t Test[] = '1 2 3 4 5 6 7 8 9 1...
