Discuss hardware and software design challenges, including NOR flash storage, OTA updates, component ID, and thermal management.
I’m a bit confused by the conflicting information regarding the STM part VN21-E. There is no MSL specified on the STM label – which makes sense given that it is a Pentwatt package (through-hole mounting = wave soldering = no real risk of MSL damage)....
Hello,I'm trying to implement the Key Establishment workflow on my hardware based on STM32U5 MCU and STSAFE-A110 secure chip. The ephemeral key pair generation (StSafeA_GenerateKeyPair) works fine and the establishing key (StSafeA_EstablishKey) with ...
Hi,Can I get the IBIS model of 54ACT157 2 input Mux IC?
I have a news that ST REMOVED SHORT CIRCUIT PROTECTION FROM TDA7294 IC, please confirm is enews real? Or not?
How to identify an original TDA7294 ? any marking or way to check? Or multimeter test reading? Please tell me the way to identify an original tda7294 ic.
Hey,i didnot find any AFR4 in option byte to set PB4-SCL and PB5-SDA of STM8s003F3. Can st will help how to enable it for I2c hardware peripheral.?
Hi guys,I am a newbie in STM world. I am struggling with a small code but failing every attempt modifying the code googling for several times. Please have a look to my code. I have defined three functions, i.e. inv_on(), inv_off(), and sw_state(). W...
Hi, I am trying to develop a capacitive liquid level detector with the STM8L152 adapting an example of the STMTouch Library.It is fine to detect if there is water or not inside a container. But when I try it in my final solution, that is to detect th...
Dear Support Team,I am planning to implement a circuit based on the TDA7293V. In this design, the IC will remain powered on, so I intend to use the circuit shown in Figure 6 (Single signal standby/mute control circuit) to prevent 'pop' noise. Given t...
Split from USART in Proteus not displaying any characters as this is now a new situation (real hardware; not simulation) Now as per your advise i have moved from simulation to real hardware can you please why under freertos its not working the led i...
