Discuss hardware and software design challenges, including NOR flash storage, OTA updates, component ID, and thermal management.
Hi everyone,I'm currently working on a project involving a stepper motor controlled by an STM32 microcontroller, and I wanted to share a quick overview of how I set it up using STM32CubeMX.Hardware:STM32F103C8T6 (Blue Pill)Stepper Motor (28BYJ-48)Ste...
Hello STI would like to ask about is it possible to change the STUSB4500 FTP_KEY default values through SMBUS interface? If its possible, could you suggest the appropriate step to do so?
Hello.Forgive me for what might be an incredibly "noob" question, but i'm not ashamed to admit that I am, in fact, a noob.I've been trying and failing and trying and moderately succeeding over the last few days using NanoEdge AI Studio creating an au...
Hey guys, can you help me find the datasheet for the L9790 chip? It's in the automatic transmission control unit. Thanks.
I need an RF communication solution which has the properties of minimum 2Mbit/s, 200m line of sight, below 1ms RF synchronization, mesh capability, 50m for tall building floor to floor, and wake on RF
I'd like to know about the write cycle for the m95p16i EEPROM.I'm using "Page write (02h)" to write 32 bytes to page 0.The first write is to address 00h, the second to address 21h.I continue to write 32 bytes at a time, writing 16 times until the las...
Since I use Linux and am accustomed to Python scripts, I decided to create a script that generates file systems with all the contents of a directory.I was inspired by the work of Jim Pettinato and Simon Goldschmidt, with no difference in the result,...
Hello ST Team, We are using the STEVAL-MKI109V3 as the motherboard and STEVAL-MKI208V1K (IIS3DWB vibration sensor) as the daughter board. We currently communicate using the USB virtual COM port at 115200 baud and send ASCII commands such as: *SETDB20...
Hi Team,I was working on STM32F103C8T6 Bluepill board. I was using this board with ST-LinkV2 to connect with CubeIDE. When i tried to flash a sample LED blink program via CubeIDE, it gave an error saying 'Target not found'. But at the same time i was...
Hi, Could you please provide the top marking information for parts VNP49N04-E and VNP35NV04-E for part verification? Thanks Jay Trivedi