Others: hardware and software

What is the gate length and channel length of POWER MOSFET?

I want to know the gate length and channel ​length of STF23N80K5 and STF26N60M2?This is for neutron affect analysis in space environment.

Does any one know the difference between M29F040B-70K6 and M29F040B-70K6F?

I cannot find any data on these and the part is obsoleteThanks George

VNI8200XP - outputs switching sporadically at power-up and power-down

Hello. I'm designing a new board where I use VNI8200XP to control some LEDs and relay loads.In my case VNI is used in SPI mode (SEL2 pulled high to Vreg), internal DC/DC converter is disabled and Vreg is supplied from on-board +24V/+5V DC/DC Converte...

STA310 Documentation - is more can be shared now?

Hello, can more of STA310 datasheets can be shared now. Eg. application manuals or example code, firmware and so on?

hi folks, i am using M58BW016FB flash memory as boot memory for MPC8358E processor in that i struct at writing a data into the memory . i am using freescale code warrior soft. for writing data into memory..

can you please help me how to write data into this flash and what are the commands and steps i have to follow....thank you.regards,venkat d

Does anyone have a copy of these files? They were mentioned in a post for an obsolete part, the ST90R158; but the links are broken. http://www.stmcu.com/mcdfiles/7241.pdf http://www.stmcu.com/mcdfiles/7620.pdf

Original post:https://community.st.com/s/question/0D50X00009Xkd3xSAB/its-possible-to-use-st90t158otp-as-rom-less-type-st90r158-help-me

Can you tell me if the following part numbers are obsolete?

M27C512-12F1LF351NThank you

Hi All, Does anybody used STUSB4500 A_B_SIDE signal for mux selecting TUSB542 IC. Regards, Vyshnav Krishnan

un38. 3 report for M4T28

Dears, during the air transportation,the Chinese customs ask the ​UN38. 3 report to confirm the safety of the M4T28 lithium battery. So we kindly ask the report. Thank you.​

How to enable GPGLL on Teseo-Liv3F module ?

I am working with Teseo-Liv3F to test NMEA0183 strings over BLSP UART 12 on my board. wanted to know how reset and wakeup are used to monitor UART transfers ?How can we enable GPGLL, GPVTG on the module to obtain NMEA strings?To test the antenna used...