Others: hardware and software
Discuss hardware and software design challenges, including NOR flash storage, OTA updates, component ID, and thermal management.
Forum Posts
USBLC6-4SC6 for EFT and lightning protection
Hi,Can USBLC6-4SC6 be used to protect an IO from EFT (IEC 61000-4-4) and lightning (IEC 61000-4-5)? I do not see any specification for these standards? Thanks.RegardsGordon
M95M04-DR EEPROM roll-over issue
I am working with the M95M04-DR eeprom. In my program, I must save logs of data inside the EEPROM memory. I wriite data in chunks of 25 bytes.I have written 11 chunks of data ant noticed a problem. I have a function to read back multiple bytes of dat...
Resolved! SMCJxxA, SMCJxxCA about IRM for the SMCJ5.0A/CA
Reading the data sheet of SMCJxxA, SMCJxxCA,for the SMCJ5.0A/CA it is specified an IRM of 500uA ( 2000uA at 85C) at 5V it seem not consistant whith the SMBJ type witch seem to be the same (exept power handling).(In SMBJXXA data sheet miss witch is bi...
Resolved! How to identify older components? Where to get datasheet of it?
At the moment I have ST MV C737, how I understand it is zener diode, but no info in internet and here. Anyone can help to identify?
Cannot issue NMEA commands to the Teseo on STEVAL-STRKT01 over good CN503 UART link.
Hello ST,I’m attempting to integrate the STEVAL-STRKT01 into my system.I need to issue NMEA commands to the Teseo .I’m connected into the UART over CN503 (TX,RX,GND only) and I can see the serial chatter.For example, I want to Stop the STAGPS engine ...
TMMDB3 part no. have \K and /HF what is the differences? is this DIAC item is polarize?
We cannot find any info about the \K and /HFWhen we try to use the /HF, which looks like it is polarized, but in TMMDB3 datasheet, it never mentioned. So we want to clarify.