Others: hardware and software

What recommendation do I follow to avoid losing data retention in NOR flash memory M29W640FT?

doubt flash memory

M24512 Current consumption in standby mode is about 90uA instead of 2uA.

Hello,Previously we are using AT24C512 I2C EEPROM(current consumption 1uA in standby),with this our device current consumption is about 4.2uA.Due to more write cycle of M24512-DF EEPROM, we just replaced AT24512 with M24512-DF. EEPROM read and write ...

Pin 1 Identification on Part ST L9637D

I have just purchased some samples of the ST L9637D from my local supplier, however Pin 1 Is not identified See attached ImageThe following is printed on the ICL9637DGK924Any suggestions woudl be appreciatedThank you

Could you please add me to the Product Change Notification list (PCN) for all products., or point me in the right direction to where I can make this request?

How does one switch the ANT_OFF GPIO pin on the LIV3F?

I have a sun system with M48T59Y-70PC1 nvram but I can´t find it, could you tell me what is the replacement for it? Thanks Ponvio

Hello! I am looking for FIT values for M95256-DRMN3TP EEPROM. Could any body please assist in calculating the FIT rate at 55°C and 80 °C and at 60 %CL aswell as 90 %CL? Thanks

SRC0CS25D !!!! In the material of the SRC0CS25D, there is threshold voltage and what is for in this component?

I did not understand that VCC range of the SRC0CS25D is 1V6-5V5 and the electrical specifications state Vth=(min,type,max)=(3v29,3v40,3v50). There is some uncertinity about the thereshold. If my VIN voltage (given to VCC pin of SRC0CS25D) is under 3....

Is it possible to get a RoHS and REACH statement for a discontinued product?

I'm specifically interested in PSD813F2A-90MI. Is it possible to get the last released statements?