Discuss hardware and software design challenges, including NOR flash storage, OTA updates, component ID, and thermal management.
What would cause an application to crash the debugger and not be able to reset in the debugger, without exiting the debugger? I am just about finished with my application I have been working on for a few months.The processor is a STM32G051K8T and I h...
Hello All,Can you please help in calculating the thermal constant (c= 0.05 /degC) of schottky diode in general? How can i calculate it for any?Was going through one of STM application note on thermal runaway of schottky diode (STPS80L15C). App note :...
Hello, I am working with an SPI M95M02-DR EEPROM in a Cypress PSoC Creator enviroment.The M95M02-DR is running on a 1 Mbps SPI bus.After each buffer write, a delay of 20 ms is used.If 0xFF is written to all bytes of a page or if random values are wri...
I used the ST eDesignSuite to make a o 90V-265V AC power input to +12V with 0.8A and -12V with 0.2A output. So I purchased all the components and soldered the pcb as below,fig1. Soldered PCBCircuit - Schematic which was taken by eDesignSuite as below...
Hi everyone,I need to read system altitude with Teseo-LIV3 GNSS Module and I would like to know if I can read a nagative altitude with it ?The only place I can see altitude is at page 97 of the User Manual in (--GGA frame) but it is described as "Hei...
Dear ST-Community,this is my first post, so: Hello!I am currently struggling with a M2425 256kbit Eeprom that i want to address via I2C. I2C-access is working and i can read and write.The part i do not understand is the addresses of the memory. The E...
Is it necessary to execute the flash controller instruction BTU of the ST10F269 out of internal flash or it can be executed from RAM or external memory.
