When installing some StellarStudio plugins http://*.srxstudio.org , you can meet the issue : sun.security.validator.ValidatorException: PKIX path building failed It is typical IT Issue :face_screaming_in_fear: in each corporate company. “"Path bui...
Dear all, We are thrilled to announce that as of today, March 1st, 2024, SR5E1 device support in StellarStudio is available to the mass market ! This means that any user can effortlessly download the official StellarStudio installation packag...
I would like to know, in the Stellar SR6G7, whether the BCS code will execute first or if we can configure a custom Boot Manager to execute first. Since I need to run secure boot with HSM, I want to configure the Boot Manager for PLL clock initializa...
When replacing L917A how should I reboot it, what hardware or software do, I need please help.*This post has been translated from Persan to comply with the ST Community guidelines.
I recently bought the STEVAL-TTM002V1 along with the AEK-MCU-SPC5LNKU debugger since it was mentioned support for SPC56 would be available before 2024. However, I haven't been able to get the AEK-MCU-SPC5LNKU debugger to work with the SPC56.I'm wonde...
I am getting the errors below when trying to build the project.Due to reasons, we regenerate the project and now this project cannot be build ...I have tried the solution at Solution 1 and Solution 2. I have check that i have the full access to the w...
Is it because some jumpers on the SPC574K exploration kit board need to be connected, or is it for other reasons that the UDE STK software cannot read the chip through the emulator of the SPC574K exploration kit board?
While debugging the board AEK-AUD-C1D9031 , the SPC5-UDESTK is not responding and it says this always even when the target power supply is turned ON and the Device is shown in Device manager. I think there will be some target configuration which I ha...
HiOn power up the SPC56EL54L5CBFS looks like it is in an internal RESET mode that does not end. The RESET pin is always pulled down by the CPU. Power up of 1.2v and 3.3v in 1.5msec. Can you help to to understand why the RESET pin is always pulled ...
Hello,I am currently exploring the SPC5Studio IDE for developing applications on SPC5 family microcontrollers and have a couple of questions regarding its features:1) Licensing Requirement:Does SPC5Studio IDE require a licensed version for full funct...
I’m engineer from EMS company. For one of our customer we are going to manufacturing PCBA (Vehicle Control Module) based on SPC58NH92C5 uC. Our customer is owner of design and our customer develop the final firmware for product. However for the manuf...
