Hi,I am trying to calibrate my IMU on a custom board using X-CUBE-MEMS package. However there is no support for the LSM9DS1 part. I've seen on the community that the alternative for the Accelerometer+Gyroscope is the LSM303AGR library. However, this ...
I have LSM6DSO sensor. I want to use fsm. In application note, I did not understand how thresh1 is calculated . For example it is written that B7AEh (-0.480)3C00h (1.000)27AEh (0.030)34CDh (0.300)I did not understand how this conversion is done.
Why did you guys remove the feature of resetting the timer for LSM6DSO IMU? It was available in LSM6DS3 by setting AAh in TIMESTAMP2_REG (42h).How do we reset the timestamp value in FIFO (LSM6DSO chip)?
HelloI have problems with Ultra Lite Driver (ULD) crosstalk functions "VL53L1X_SetXtalk()" and "VL53L1X_GetXtalk()". I'm not sure if I have made a mistake or if there is an error in the ULD. I will give an example to explain my problem. #############...
I recently purchased VL53L1X ToF laser ranging sensor and for the last couple of weeks I am trying to make it work. Based on reference schematic from the datasheet I built the following setup:Using STM32L011 uCU, ULD API and LowLevel I2C libraries ...
I have checked -9 means failed to set clock. I have run debug trace on it, I have attached the point where it is thowing error. I am new to this kindly someone guide me what I am doing wrong. Or kindly point me toward any working implementation of MP...
Calling status = sensor_vl53l1.VL53L1_GetMeasurementDataReady(&NewDataReady);from the Example, I get only status = 0 and NewDataReady = 0;I stepped into the functions down to the Device access via I2C.All went well so far. I got: gpio__tio_hv_...
Unused code detected:VL53L1_Error VL53L1::VL53L1_RdByte(VL53L1_DEV Dev, uint16_t index, uint8_t *data){ int status; status = VL53L1_I2CRead(Dev->I2cDevAddr, index, data, 1); //FR bug :: I2CRead exits always with 0! why the following check? Unused...
