Hi, I've been using the STEVAL-MKI208V1K for a year now, without problem, but now I tried to connect the two parts using a longer cable (twice the length of the one provided with the kit). While my microcontroller says the sensor is connected, when c...
We are thinking of using few features from x-cube-mems1 package and would like to know if it can be used for nRF9160 MCU.
Hi, I would like to know which is the mass (or weight) of LIS3DH accelerometer.Thanks
Hi!Reading the documentation of the LIS3MDL I cannot find an answer about the behaviour of the interrupt generator.When using the device in power down, and setting the threshold values in the registers, does the device keep sampling all the time unti...
I'm trying to get the sensor value with stm32Maybe because I connected the board to one i2c and attached two sensors, the value didn't changeMost people use cereal, but I only use C, so I have to use HALThe sensor that allows you to read only one is ...
I don't know how to use several sensor modules with stm32 spiThey told me to use the code I received, but I think it's wrong because even if I connect the sensor and run the code, the same value comes outDo I have to fix all the codes below? Or do I ...
Hi,I am trying to use IMP34DT05 PDM Mic with an Audio Codec.The audio codec was previously interfaced with SPM0423HD4H-WB PDM Mic and worked as expected.When I try to use the IMP34DT05 Mic, however, I see no data transmitted on the data lines. The cl...
Setup- Mikroe LSM6DSL Click on Microchip PIC24F Curiosity Board, Salaea Logic I2C protocol analyzer. Yes I use a wrist strap, ESD mat, and grounded Weller soldering iron. Why didn't ST use rounding in their Accel Self-Test? Should I?
Hello, in 2021 I developed a Zephyr 2.6.0 based app which interfaces with STMicro's IIS2DH accelerometer. During development stages I was able to talk more directly to this sensor through Zephyr's I2C API, by passing the following member of a valid I...
