Vl53l8 configuring the ranging frequency

[vishnusf]

Hi,

I am using the VL53l8 sensor. i need to change the ranging frequency. im using the Xcube tof code. I see in the app tof code that #define RANGING_FREQUENCY (10U). so if i change 10u to 15. Willi get ranging frequency to 15 hz.?

Thank u 

[John E KVAM · Accepted solution]

that should work just fine. 

and, as you are using an STM32, go ahead and insert:

//Counting cycles is a piece of cake. 
//Stick this code somewhere in your code.

       cur_timestamp = HAL_GetTick();
       printf("%4lums \n",cur_timestamp - prev_timestamp);
       prev_timestamp = cur_timestamp;

Each tick is a ms. - but remember that there is going to be a roll-over at some point. But it's great for just testing!!