I am wanting to design a device that incorporates several TOF sensors in a uni-dimensional array for detecting an objects location. The sensors would have approximately 8mm of separation. Will they interfere with one another?
For the past week or so I've been trying to interface this sensor. I've reached a point where I get no errors during the firmware download and initialisation of this sensor. Using the example, I then start ranging (which gives a 255 error?), but when...
For VL53L3CX, how do we measure frame rate during ranging ? I have reviewed datasheet but no information found in this.Any help or information will be very much appreciated.
Hello community, How to know the length in distance for the width of each bin in range histogram?Also some clarity of how these widths are generated (if there is any documents on this) will be helpful.a histogram is made of 20 binswhat is distance of...
Hi Sir,I am testing the Pololu VL53L1x with TI Controller.The test detects and counts the people ( normally 300 to 500 per day) in the test unit which is a 24x7 functioning unit.I never turned off the power of the sensor. it works for continuously 13...
Hi, I have two vl53l5cx sensors in my system. I need to change (at least one) of the device addresses. I used the instructions from n UM2884, section 2.3, that is.Power up the system.Reset the sensor by LPn pin LOW, I2C_Reset HIGH, wait 500msec, LPn...
Hello all,i have 2 VD6283TX sensors connected on 1 i2c handler and i want to change adress on one of them. Which command should i send to sensor to change adress ?Something like this ? HAL_I2C_Master_Transmit(hi2c, A2_LIGHT_SENSOR_INSTANCE_0, txBuffe...
When VL53L5CX Time-of-Flight sensor is in threshold detect mode, will it trigger only on what would be a Status 5 valid distance? Thanks! -Doug
The functions vl53l5cx_motion_indicator_init and vl53l5cx_motion_indicator_set_resolution rely on code in vl53l5cx_motion_indicator_set_resolution to update the sensor settings. However, the code only executes if an error is encountered prior to th...