Posted on September 18, 2017 at 13:13HelloI am trying to implement a I2C driver on a SPC58EC.The problem I am facing now is that I cannot get the signal output on the pads correctly.IBSR.IBAL is immediately set when I try to generate a START conditi...
After IIC module is initialized, when I prepared the data and to write the IBCR register to send it, after the register is written with the value 0x70(master mode, tx mode, interrupt enable and generate START condition), the value read from the IBCR ...
Hi,May i know which pin on SPC57S-Eval kit board use for serial clock and serial data?I want to connect the gyroscope sensor to the board.
I created my I2C test project, and click import samples from application library.Then, select SPC58EC-DISP, but there is no I2C Driver in Drivers tab.But, my colleague's SPC5 Studio figure out I2C Driver.What should I do to figure out I2C Driver?Atta...
Hello I'm sharan from yali mobilities. Here we are shifting from old spc5 studio to latest version spc5 studio 6.0. For testing I2C, I have used Arduino as a slave device. The programme which I have writen is attached as image. Arduino sends a ...
Posted on May 06, 2016 at 15:02Hi all,I'm currently working on a project where I need I2C communication between a SPC560C and an RTC. I'm using SPC5 studio for this, and when I go to ''SPC560BCxx Low Lever Drivers Components RLA'' there is a checkma...