FAQs
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 

Generate the drivers in SPC5 studio

Saravanan_Mari
Associate III

‎2020-11-11 02:51 AM

Hi everyone,

Iam saravanan working as Embedded software developer at iELEKTRON Technologies

We are kick start our BLDC driver development project for that Our hardware team selected the SPC5P series controller ,then we ordered the Evaluation kit which is arriving next week

before that we are analysing the SPC Envoinment for that i downloaded the SPC5 studio in that we have some quries

1.First from some documentation i found that create a SPC5 project then in the Screenshot (i added the component to the SPC560pxx Platform Component RLA) 0693W000005B1x7QAC.png2.Can anyone help me how to configure the GPIO,UART,SPI etc and generate the drives is any documents available or any video refernce for SPC560p controller

Please help us on this regard

thanks in advance

This discussion has been locked for participation. If you have a question, please start a new topic in order to ask your question
1 REPLY 1
Giuseppe DI-GIORE
ST Employee

‎2020-11-13 07:40 AM

Hello,

clicking on SP560Pxx Low Level Drivers Component RLA

will open a configuration panel for all device drivers supported on SPC560P (UART, SPI, CAN, etc).

do not forget to open also the Outline view required to configure the drivers.

To configure the GPIO you can either:

  1. open the PinMap wizard and configure each single pin
  2. click on SP560Pxx Board Initialization Component RLA and configure the GPIOs

Have a look at the following tutorials (ignore AutioDevkit which is not supported by SPC560P):

Part #1: https://www.youtube.com/watch?v=WDp4XmmwEwc

Part #2: https://www.youtube.com/watch?v=pQeyJQBHV1c

Part #3: https://www.youtube.com/watch?v=3iCMWjYalwg

Part #[4: https://www.youtube.com/watch?v=3iCMWjYalwg] 

Regards,

Giuseppe

0 Kudos
Top