When installing some StellarStudio plugins http://*.srxstudio.org , you can meet the issue : sun.security.validator.ValidatorException: PKIX path building failed It is typical IT Issue :face_screaming_in_fear: in each corporate company. “"Path bui...
Dear all, We are thrilled to announce that as of today, March 1st, 2024, SR5E1 device support in StellarStudio is available to the mass market ! This means that any user can effortlessly download the official StellarStudio installation packag...
Posted on October 21, 2015 at 18:21Hi all, I'm using the SPC560B ecu as a LIN slave controller. Now I have the problem to wake up a slave master. Therefore I only set LINFLEX_0.LINCR2.B.WURQ = 1. This works for a couple of times but after a few wake...
Posted on October 20, 2015 at 14:44Hello all, I’m trying to initialize the LinFlex LINFLEX_1 module of the SPC560B Bolero. Unluckily I’m running into problems writing the LINFLEX_1.LINCR1 register. Specially I’m unable to write the LINFLEX_1.LINCR1...
Posted on October 10, 2015 at 09:57Hi,I am testing SPC560P50L5 with spc5_studio, the built-in example for FlexCAN is loopback test. When I disable loopback and enable supervisor mode, there is nothing on the CAN_TXD pin. I do not know the problem, a...
Posted on October 14, 2015 at 15:30Pin wizard was so buggy on SPC564B74L7 I decided to use the standard declaration. On SPC56EL60's RM we can find input mux select config (PSMI) for each input function. On SPC564B74 the RM the PSMI config are placed...
Posted on November 19, 2014 at 16:24Hello,I am trying to make a simple project that for a start can send a single CAN frame.I am using the SPC560B-DIS evb without any CAN board (will connect later on my own converter).I took a CAN sample from other...
Posted on October 06, 2015 at 09:27HI,We are going to use SPC5604B for the coming project, and have installed SPC5Studio, and also imported all the components, but still dont find low level drivers for SPC5604B, but found lld for SPC5604P, but seem...
Posted on October 01, 2015 at 14:11Hello,I want to use a pre-processor directive for conditional compilation. I have a piece of code which I want to include when a pre-processor directive is defined. Where to define this in SPC5Studio? Which setting...
Posted on September 28, 2015 at 14:11Hello Forum members,I am trying to implement a Function On RAM But i did not find any thing on st Refrences. I found this example in freescale but spcstudio can not compile the code . __declspec(section ''.text_i...
Posted on September 08, 2015 at 10:38Hi members I want to jump from address 0 to 0x8000 in flash how can i do this ? best Regards Nazerian Vanima
Posted on May 13, 2015 at 10:58 Hello, I would like to reload PWM duty cycle every 10 PWM periods using DMA functionality. Therefore I configured FlexPWM subodule 0 and DMA channel An array stores 8 different values for VAL3 register which eq...