Automotive MCUs

cancel
Showing results for 
Search instead for 
Did you mean: 

Forum Posts

How to install your Root Certificate in StellarStudio JRE

When installing some StellarStudio  plugins http://*.srxstudio.org , you can meet the issue : sun.security.validator.ValidatorException: PKIX path building failed  It is typical IT Issue :face_screaming_in_fear:  in each corporate company. “"Path bui...

StellarStudio SR5E1 support is open to the mass market !

Dear all,   We are thrilled to announce that as of today, March 1st, 2024, SR5E1 device support in StellarStudio is available to the mass market !   This means that any user can effortlessly download the official StellarStudio installation packag...

preview.png

Resolved! ADC example for SPC560B-DIS not working

I imported the SPC560Bxx_RLA ADC example. As I understand, this example use ADC conversion with DMA, and the ADC value will be converted to the delay time between each time LED D8 is toggled.But some type like uint32_t could not be resolved and I tri...

fiinfi by Associate II
  • 122 Views
  • 2 replies
  • 0 kudos

Caching issue with SPC58

Hi, We're testing an SPC58NN84E7 and encountering an issue with the ADC in DMA mode. Our debugger is an SPD5-UDESTK interfaced via OpenOCD.When inspecting the ADC's DMA result buffer through the debugger, all values appear valid. However, unexpected ...

sacha by Associate
  • 76 Views
  • 0 replies
  • 0 kudos

Resolved! SPC5 Studio

Hello, I am Erdem.I am an R&D engineer at Devimsel Elektronik. I will use the SPC560P processor on my own PCB board. For this I need instructions for using SPC5 studio. How do I make configurations such as pin and clock tree? Can I get an instruction...

Eakso.1 by Associate II
  • 1323 Views
  • 5 replies
  • 1 kudos

EV-VN9D30Q100F for SPC582B-DIS or SPC58EC-DIS GUI firmware

Hi,i need some help for the EV-VN9D30Q100F. It says there is a dedicated Software for the SPC582B-DIS or /EV but i can't find it nowhere. The board connects to the GUI (STSW-EV-M09SPI), so far so good, but without the firmware on the MCU, i can't tes...

PNeub.2 by Associate II
  • 101 Views
  • 0 replies
  • 0 kudos

SPC5 debug and flash programming

Hello, We are currently developing a board for a customer with a SPC564B74L7 (his choice, not ours). Now we need a tool to debug through JTAG and to program the flash.Is SPC5-UDEDEBG-TL enough? Do we need specific software or should we use STELLARLIN...

SPC58NH-DISP CAN Test Application available?

Hello,We are trying to get setup with the SPC58NH-DISP board and are having issues with getting CAN communication going. I attempted to manually adjust the CAN Bootloader test application to send a simple message over CAN J2 but have not had any luck...

LTrap1 by Associate
  • 102 Views
  • 0 replies
  • 0 kudos