Interface and Connectivity ICs
MEMS and Sensors
Analog and Audio
EMI Filtering and Signal Conditioning
Power Management and Motor Control
SPC5 Automotive MCUs
ST25 NFC/RFID Tags and Readers
Switches and Multiplexers
STM32 MCUs Community
MEMS and Sensors Community
Automotive MCUs Community
STM8 MCUs Community
Help the community
Share your activities
Contribute your knowledge
About this community
to create and rate content, and to follow, bookmark, and share content with other members.
Question asked by
on Dec 4, 2009
on May 17, 2011 by 29599
Show 0 Likes
No one else has this question
Mark as assumed answered
This content has been marked as final.
Show 1 comment
(Required, will not be published)
May 17, 2011 10:00 AM
Ethernet layer 1 end equipment test(method)
For validation / qualification of the Ethernet port hardware on one of our intrusion security products I'm searching for dedicated equipment/tools and test method to test this. It should cover 10Mbase/T and 100Mbase/TX link speed (other link speeds are out of scope).
I currently use a STE101 Phy, in combination with a STR921 micro.
The goal is to have a clear overview of all layer 1 characteristics and the status compared to the ideal situation. Also layer2/3 info is most welcome.
Points of interest:
· AC/DC characteristics
· Carrier quality, etc
I'm trying to validate the hardware for a single Ethernet port and not trying to validate an Ethernet network, and so the test equipment/tools/method should be dedicated to this.
Show 0 Likes
Retrieving data ...
2018 STM32 Wish List
CubeMX SDIO DMA FatFS configuration
Please provide a way to download older version of the cube.
Efficiently use DMA with UART RX on STM32
Example code for stm32f4 SD card read via SPI