Interface and Connectivity ICs
MEMS and Sensors
Analog and Audio
EMI Filtering and Signal Conditioning
Power Management and Motor Control
SPC5 Automotive MCUs
ST25 NFC/RFID Tags and Readers
Switches and Multiplexers
STM32 MCUs Community
MEMS and Sensors Community
Automotive MCUs Community
STM8 MCUs Community
Help the community
Share your activities
Contribute your knowledge
About this community
to create and rate content, and to follow, bookmark, and share content with other members.
Question asked by
on May 7, 2004
on May 3, 2004 by 13236
Show 0 Likes
No one else has this question
Mark as assumed answered
This content has been marked as final.
Show 1 comment
(Required, will not be published)
May 3, 2004 8:37 PM
I just finished scanning the April reference manual. THe boot loader section is still missing any details. To quote:
188.8.131.52 Loader stored in Internal RAM via serial interface
In this case the “loader” code is stored in internal RAM through a serial interface (UART).
The communication protocol to download the loader in RAM is fully specified and managed
by STMicroelectronics. Please refer to “STR71x Flash Programmer” documentation for
I can't find the referenced documentation anywhere.
Show 0 Likes
Retrieving data ...
2018 STM32 Wish List
STM32F769I-DISCO: No audio output from wm8994
STM32CubeMX V4.24.0 code generation failure (bug report)
CubeMX SDIO DMA FatFS configuration
Please provide a way to download older version of the cube.