Interface and Connectivity ICs
MEMS and Sensors
Analog and Audio
EMI Filtering and Signal Conditioning
Power Management and Motor Control
SPC5 Automotive MCUs
ST25 NFC/RFID Tags and Readers
Switches and Multiplexers
STM32 MCUs Community
MEMS and Sensors Community
Automotive MCUs Community
STM8 MCUs Community
Help the community
Share your activities
Contribute your knowledge
About this community
to create and rate content, and to follow, bookmark, and share content with other members.
Question asked by
on Mar 18, 2009
on Mar 18, 2009 by 19106
Show 0 Likes
No one else has this question
Mark as assumed answered
This content has been marked as final.
Show 1 comment
(Required, will not be published)
Mar 18, 2009 6:50 AM
I'm fighting with spurios resets yet.
After Reset, the WKP_RES is always set.
The WAKEUP-Pin is used for XTI ISR
(P0.15) in my Appl.
According to the Ref. the Pin is "functional" after
The P0.15 is pulled to High, but should'nt rise
the Flag in RRCU-CFR, or?
I'm working with IAR.
Can you explain this behavior please?
Show 0 Likes
Retrieving data ...
2018 STM32 Wish List
STM32F769I-DISCO: No audio output from wm8994
CubeMX SDIO DMA FatFS configuration
Please provide a way to download older version of the cube.
Efficiently use DMA with UART RX on STM32