Interface and Connectivity ICs
MEMS and Sensors
Analog and Audio
EMI Filtering and Signal Conditioning
Power Management and Motor Control
SPC5 Automotive MCUs
ST25 NFC/RFID Tags and Readers
Switches and Multiplexers
STM32 MCUs Community
MEMS and Sensors Community
Automotive MCUs Community
STM8 MCUs Community
Help the community
Share your activities
Contribute your knowledge
About this community
to create and rate content, and to follow, bookmark, and share content with other members.
Question asked by
on Mar 21, 2009
on Mar 21, 2009 by 15532
Show 0 Likes
No one else has this question
Mark as assumed answered
This content has been marked as final.
Show 1 comment
(Required, will not be published)
Mar 21, 2009 7:02 AM
Hi the very few guys on this forum!
I'm trying to start a new board with a ST7FOXK1 for the first time!
New controler, new tool (R-link from RAISONANCE). As using RIDE7 seems to be a big mess with assembly I'm using ST STVD7.
To test I'm using a program already running on a ST7LITE19. I've adapted the "BYTES" word and the ports init. I'm able to build my project to program the device to run step by step but nothing happends? I've reduced the program to just the init and setting a port to light a led!
I suppose there are some registers, not existing on the ST7LITE19, I have to write but I've looked for a while and don't find them! Maybe the interrup mapping is different (segment "vectit")?
Could someone help me ? A little exemple project just to drive a port will be welcome!
Show 0 Likes
Retrieving data ...
2018 STM32 Wish List
STM32-C2C (Cellular to Cloud) Web Concierge Portal
STM32F769I-DISCO: No audio output from wm8994
STM32CubeMX V4.24.0 code generation failure (bug report)
CubeMX SDIO DMA FatFS configuration