Is there is any way to print the output on the console ..?
Debugging and profiling your STM32 device using Atollic TrueSTUDIO for STM32 - YouTube
Vitalij Svetashov I followed the steps like in the video but still not displaying the message of printf in console !!!
show message on Console
So perhaps you haven't correctly configured the right USART and pin, or you have forgotten to set the jumpers (JP15 and JP19 on the STM32479I-EVAL) to get the data out of the ST-LINK VCP vs the RS232 connector on the board.
USART1 PA9 and PA10
Retrieving data ...