Interface and Connectivity ICs
MEMS and Sensors
Analog and Audio
EMI Filtering and Signal Conditioning
Power Management and Motor Control
SPC5 Automotive MCUs
ST25 NFC/RFID Tags and Readers
Switches and Multiplexers
STM32 MCUs Community
MEMS and Sensors Community
Automotive MCUs Community
STM8 MCUs Community
Help the community
Share your activities
Contribute your knowledge
About this community
to create and rate content, and to follow, bookmark, and share content with other members.
Question asked by
on Mar 22, 2007
on Mar 22, 2007 by 18370
Show 0 Likes
No one else has this question
Mark as assumed answered
This content has been marked as final.
Show 1 comment
(Required, will not be published)
Mar 22, 2007 11:10 AM
I work with STR751 device and IAR Embedded Workbanch.
I debug my application and when the program get to the command
MRCC->CLKCTL |= MRCC_CKSEL_Set_Mask;
i get an error (please see attached file error.jpg).
The application is a variant of device firmware update based on ST examples.
The code location is divided to B0F0 and B1F0 and the firmware on B0F1-3.
Thanks in advance.
Show 0 Likes
Retrieving data ...
2018 STM32 Wish List
stm32 with Cubemx Adafruit FRAM MB85RC256V I2c
CubeMX SDIO DMA FatFS configuration
Please provide a way to download older version of the cube.
Efficiently use DMA with UART RX on STM32