what is the default system clock frequency (previous that all clock configuration take place) on the development board "STM32F767 Nucleo-144"?
Where I can find this information?
Thank you for the answer.
I would know what is the default clock source, and its clock frequency, before the PLL and the clock distribution network is initialized.
I'm confused about what exactly the question is asking.
The F7 has an HSI clock of 16 MHz that it starts with.
The NUCLEO-144 has an 8 MHz HSE clock source, ie HSE_BYPASS
Most of the examples engage the PLL and run at 216 MHz
>>Where I can find this information?
The Reference Manual for the chip family
The User Manual/Schematic for the NUCLEO-144
The Data Sheet for the chip
The Examples in the HAL source trees
Runs at 16 MHz (HSI) out of reset. Chip thing, not a board thing.
Thank you very much!
Retrieving data ...