AnsweredAssumed Answered

cannot program to esc001v1

Question asked by Low Yik Seong jordan on Apr 24, 2018
Latest reply on Apr 24, 2018 by Low Yik Seong jordan

Hi, i could not program my esc001v1 as the IAR workbench keep popping the message fatal error, no mcu device detected. I have follow every step in st official website but I am stuck at downloading the program to the motor driver. 

I supply 12V power to motor driver, follow by connect the motor driver using st-link/v2 programmer. Advice please?

Outcomes