AnsweredAssumed Answered

How to build DTM for BlueNRG-1 from sources?

Question asked by romaniuk.piotr on Apr 18, 2018
Latest reply on May 12, 2018 by romaniuk.piotr

Hi,

I cannot build working DTM for BlueNRG-1 on TrueSTUDIO (9.0.0).

 

When I program the device with prebuilt DTM_SPI.hex from Firmware folder in ST Development Kit it works fine. STM32 connects with BlueNRG, configures it, etc.


Unfortunatelly, the program built from sources (Projects/BLE_Examples/BlueNRG-1/DTM) is not working. It looks like BlueNRG does not raise IRQ line for notification its initial event.

Below I illustrate comparison of initial sequence for these two programs.

 

Initial sequence for DTM built from sources and prebuilt in .hex file.

What I am missing in compilation?

Regards,

Piotr

PS
I am using idb007v1 board.

Outcomes