Interface and Connectivity ICs
MEMS and Sensors
Analog and Audio
EMI Filtering and Signal Conditioning
Power Management and Motor Control
SPC5 Automotive MCUs
ST25 NFC/RFID Tags and Readers
Switches and Multiplexers
STM32 MCUs Community
MEMS and Sensors Community
Automotive MCUs Community
STM8 MCUs Community
Help the community
Share your activities
Contribute your knowledge
About this community
to create and rate content, and to follow, bookmark, and share content with other members.
Question asked by
on Aug 24, 2005
on May 17, 2011 by 16663
Show 0 Likes
No one else has this question
Mark as assumed answered
This content has been marked as final.
Show 1 comment
(Required, will not be published)
May 17, 2011 12:02 PM
Thanks for your reply. There are some other questions from me. Hopefully that you could explain for me.
May I know the connection of J2? Can I connect the JEN, TRSTN, CNTL and RSTN to Vcc? May I know the connection of the loop back cable. I did not use header in my prototype. I straight away connected those pins to the designated destination. (eg. TCK to pin 19 of PSD834) Will it caused any problem?
One more question is regarding the chip used in the construction of JTAG programmer. I used 74LS04 instead of 54ALS05. I thought it would be ok since 2 of them are inverter. Will that be a problem as well?
Thanks for taking time to answer my inquiries. Your help is greatly appreciated.
Show 0 Likes
Retrieving data ...
2018 STM32 Wish List
STM32-C2C (Cellular to Cloud) Web Concierge Portal
STM32F769I-DISCO: No audio output from wm8994
STM32CubeMX V4.24.0 code generation failure (bug report)
CubeMX SDIO DMA FatFS configuration